Filters
AMC1.2 CAT.IDE.H.190 Flight data recorder
ED Decision 2016/012/R
OPERATIONAL PERFORMANCE REQUIREMENTS FOR HELICOPTERS HAVING AN MCTOM OF MORE THAN 3 175 KG AND FIRST ISSUED WITH AN INDIVIDUAL CofA ON OR AFTER 1 JANUARY 2023
(a)The operational performance requirements for FDRs should be those laid down in EUROCAE Document 112A (Minimum Operational Performance Specification for Crash Protected Airborne Recorder Systems) dated September 2013, or any later equivalent standard produced by EUROCAE.
(b)The FDR should, with reference to a timescale, record:
(1)the list of parameters in Table 1 below;
(2)the additional parameters listed in Table 2 below, when the information data source for the parameter is used by helicopter systems or is available on the instrument panel for use by the flight crew to operate the helicopter; and
(3)any dedicated parameters related to novel or unique design or operational characteristics of the helicopter as determined by the Agency.
(c)The parameters to be recorded should meet the performance specifications (range, sampling intervals, accuracy limits and resolution in read-out) as defined in the relevant tables of EUROCAE Document 112A, or any later equivalent standard produced by EUROCAE.
Table 1: FDR — All helicopters
No* | Parameter |
1 | Time or relative time count |
2 | Pressure altitude |
3 | Indicated airspeed or calibrated airspeed |
4 | Heading |
5 | Normal acceleration |
6 | Pitch attitude |
7 | Roll attitude |
8 | Manual radio transmission keying CVR/FDR synchronisation reference |
9 9a 9b 9c 9d 9e | Power on each engine: Free power turbine speed (NF) Engine torque Engine gas generator speed (NG) Flight crew compartment power control position Other parameters to enable engine power to be determined |
10 10a 10b | Rotor: Main rotor speed Rotor brake (if installed) |
11 11a 11b 11c 11d 11e 11f | Primary flight controls — pilot input or control output position if it is possible to derive either the control input or the control movement (one from the other) for all modes of operation and flight regimes. Otherwise, pilot input and control output position: Collective pitch Longitudinal cyclic pitch Lateral cyclic pitch Tail rotor pedal Controllable stabilator (if applicable) Hydraulic selection |
12 | Hydraulics low pressure (each system should be recorded) |
13 | Outside air temperature |
18 | Yaw rate or yaw acceleration |
20 | Longitudinal acceleration (body axis) |
21 | Lateral acceleration |
25 | Marker beacon passage |
26 | Warnings — including master warning, gearbox low oil pressure and stability augmentation system failure, and other ‘red’ warnings where the warning condition cannot be determined from other parameters or from the cockpit voice recorder |
27 | Each navigation receiver frequency selection |
37 | Engine control modes |
* The number in the left-hand column reflects the serial numbers depicted in EUROCAE Document 112A.
Table 2: FDR - Helicopters for which the data source for the parameter is either used by the helicopter systems or is available on the instrument panel for use by the flight crew to operate the helicopter
No* | Parameter |
14 | AFCS mode and engagement status (showing which systems are engaged and which primary modes are controlling the flight path) |
15 | Stability augmentation system engagement (each system should be recorded) |
16 | Main gear box oil pressure |
17 17a 17b 17c | Gear box oil temperature: Main gear box oil temperature Intermediate gear box oil temperature Tail rotor gear box oil temperature |
19 | Indicated sling load force (if signals are readily available) |
22 | Radio altitude |
23 23a 23b 23c | Vertical deviation — the approach aid in use should be recorded: ILS glide path MLS elevation GNSS approach path |
24 24a 24b 24c | Horizontal deviation — the approach aid in use should be recorded: ILS localiser MLS azimuth GNSS approach path |
28 | DME 1 & 2 distances |
29 29a 29b 29c 29d 29e 29f | Navigation data: Drift angle Wind speed Wind direction Latitude Longitude Ground speed |
30 | Landing gear or gear selector position |
31 | Engine exhaust gas temperature (T4) |
32 | Turbine inlet temperature (TIT)/interstage turbine temperature ITT) |
33 | Fuel contents |
34 | Altitude rate (vertical speed) — only necessary when available from cockpit instruments |
35 | Ice detection |
36 36a 36b 36c 36d 36e | Helicopter health and usage monitor system (HUMS): Engine data Chip detector Track timing Exceedance discretes Broadband average engine vibration |
38 38a 38b | Selected barometric setting — to be recorded for helicopters where the parameter is displayed electronically: Pilot Co-pilot |
39 | Selected altitude (all pilot selectable modes of operation) — to be recorded for the helicopters where the parameter is displayed electronically |
40 | Selected speed (all pilot selectable modes of operation) — to be recorded for the helicopters where the parameter is displayed electronically |
41 | Selected Mach (all pilot selectable modes of operation) — to be recorded for the helicopters where the parameter is displayed electronically |
42 | Selected vertical speed (all pilot selectable modes of operation) — to be recorded for the helicopters where the parameter is displayed electronically |
43 | Selected heading (all pilot selectable modes of operation) — to be recorded for the helicopters where the parameter is displayed electronically |
44 | Selected flight path (all pilot selectable modes of operation) — to be recorded for the helicopters where the parameter is displayed electronically |
45 | Selected decision height (all pilot selectable modes of operation) — to be recorded for the helicopters where the parameter is displayed electronically |
46 46a 46b | EFIS display format (showing the display system status): Pilot First officer |
47 | Multi-function/engine/alerts display format (showing the display system status) |
48 | Event marker |
49 49a 49b 49c | Status of ground proximity warning system (GPWS)/terrain awareness warning system (TAWS)/ground collision avoidance system (GCAS): Selection of terrain display mode including pop-up display status — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification Terrain alerts, both cautions and warnings, and advisories — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification On/off switch position – for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification |
50 50a 50b
| Traffic alert and collision avoidance system (TCAS)/airborne collision avoidance system (ACAS): Combined control — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification Vertical control — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification Up advisory — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification Down advisory — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification Sensitivity level — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification |
51 51a 51b 51c 51d | Primary flight controls — pilot input forces: Collective pitch — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification Longitudinal cyclic pitch — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification Lateral cyclic pitch — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification Tail rotor pedal — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification |
52 | Computed centre of gravity — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification |
53 | Helicopter computed weight — for helicopters type certified before 1 January 2023, to be recorded only if this does not require extensive modification |
* The number in the left-hand column reflects the serial numbers depicted in EUROCAE Document 112A.
AMC2 CAT.IDE.H.190 Flight data recorder
ED Decision 2019/019/R
LIST OF PARAMETERS TO BE RECORDED FOR HELICOPTERS HAVING AN MCTOM OF MORE THAN 3 175 KG AND FIRST ISSUED WITH AN INDIVIDUAL COFA ON OR AFTER 1 AUGUST 1999 AND BEFORE 1 JANUARY 2016 AND HELICOPTERS HAVING AN MCTOM OF MORE THAN 7 000 KG OR AN MOPSC OF MORE THAN 9 AND FIRST ISSUED WITH AN INDIVIDUAL COFA ON OR AFTER 1 JANUARY 1989 AND BEFORE 1 AUGUST 1999
(a)The FDR should, with reference to a timescale, record:
(1)for helicopters with an MCTOM between 3 175 kg and 7 000 kg the parameters listed in Table 1 below;
(2)for helicopters with an MCTOM of more than 7 000 kg the parameters listed in Table 2 below;
(3)for helicopters equipped with electronic display systems, the additional parameters listed in Table 3 below; and
(4)any dedicated parameters relating to novel or unique design or operational characteristics of the helicopter.
(b)The FDR of helicopters with an MCTOM of more than 7 000 kg does not need to record parameter 19 of Table 2 below, if any of the following conditions are met:
(1)the sensor is not readily available; or
(2)a change is required in the equipment that generates the data.
(c)Individual parameters that can be derived by calculation from the other recorded parameters need not to be recorded, if agreed by the competent authority.
(d)The parameters should meet, as far as practicable, the performance specifications (range, sampling intervals, accuracy limits and resolution in read-out) defined in AMC3 CAT.IDE.H.190.
(e)If recording capacity is available, as many of the additional parameters as possible specified in table II-A.2 of EUROCAE Document ED 112 dated March 2003 should be recorded.
(f)For the purpose of this AMC, a sensor is considered ‘readily available’ when it is already available or can be easily incorporated.
Table 1
Helicopters with an MCTOM of 7 000 kg or less
No | Parameter |
1 | Time or relative time count |
2 | Pressure altitude |
3 | Indicated airspeed or calibrated airspeed |
4 | Heading |
5 | Normal acceleration |
6 | Pitch attitude |
7 | Roll attitude |
8 | Manual radio transmission keying |
9 | Power on each engine (free power turbine speed and engine torque)/cockpit power control position (if applicable) |
10a 10b | Main rotor speed Rotor brake (if installed) |
11 11a 11b 11c 11d 11e 11f | Primary flight controls — pilot input and control output position (if applicable) Collective pitch Longitudinal cyclic pitch Lateral cyclic pitch Tail rotor pedal Controllable stabiliser Hydraulic selection |
13 | Outside air temperature |
14 | Autopilot engagement status |
15 | Stability augmentation system engagement |
26 | Warnings |
Table 2
Helicopters with an MCTOM of more than 7 000 kg
No | Parameter |
1 | Time or relative time count |
2 | Pressure altitude |
3 | Indicated airspeed or calibrated airspeed |
4 | Heading |
5 | Normal acceleration |
6 | Pitch attitude |
7 | Roll attitude |
8 | Manual radio transmission keying |
9 | Power on each engine (free power turbine speed and engine torque)/cockpit power control position (if applicable) |
10a 10b | Main rotor speed Rotor brake (if installed) |
11 11a 11b 11c 11d 11e 11f | Primary flight controls — pilot input and control output position (if applicable) Collective pitch Longitudinal cyclic pitch Lateral cyclic pitch Tail rotor pedal Controllable stabiliser Hydraulic selection |
12 | Hydraulics low pressure |
13 | Outside air temperature |
14 | AFCS mode and engagement status |
15 | Stability augmentation system engagement |
16 | Main gear box oil pressure |
17 | Main gear box oil temperature |
18 | Yaw rate or yaw acceleration |
19 | Indicated sling load force (if installed) |
20 | Longitudinal acceleration (body axis) |
21 | Lateral acceleration |
22 | Radio altitude |
23 | Vertical beam deviation (ILS glide path or MLS elevation) |
24 | Horizontal beam deviation (ILS localiser or MLS azimuth) |
25 | Marker beacon passage |
26 | Warnings |
27 | Reserved (navigation receiver frequency selection is recommended) |
28 | Reserved (DME distance is recommended) |
29 | Reserved (navigation data are recommended) |
30 | Landing gear or gear selector position |
Table 3
Helicopters equipped with electronic display systems
No | Parameter |
38 | Selected barometric setting (each pilot station) |
39 | Selected altitude |
40 | Selected speed |
41 | Selected Mach |
42 | Selected vertical speed |
43 | Selected heading |
44 | Selected flight path |
45 | Selected decision height |
46 | EFIS display format |
47 | Multi-function/engine/alerts display format |