ED Decision 2003/15/RM
For each exhaust system:
(a) There must be means for thermal expansion of manifolds and pipes;
(b) There must be means to prevent local hot spots;
(c) Exhaust gases must discharge clear of the engine air intake, fuel system components, and drains;
(d) Each exhaust system part with a surface hot enough to ignite flammable fluids or vapours must be located or shielded so that leakage from any system carrying flammable fluids or vapours will not result in a fire caused by impingement of the fluids or vapours on any part of the exhaust system including shields for the exhaust system;
(e) Exhaust gases may not impair pilot vision at night due to glare;
(f) If significant traps exist, each turbine engine exhaust system must have drains discharging clear of the rotorcraft, in any normal ground and flight attitudes, to prevent fuel accumulation after the failure of an attempted engine start; and
(g) Each exhaust heat exchanger must incorporate means to prevent blockage of the exhaust port after any internal heat exchanger failure.
ED Decision 2003/15/RM
(a) Exhaust piping must be heat and corrosion resistant and must have provisions to prevent failure due to expansion by operating temperatures.
(b) Exhaust piping must be supported to withstand any vibration and inertia loads to which it would be subjected in operations.
(c) Exhaust piping connected to components between which relative motion could exist must have provisions for flexibility.