Lithium batteries (Non-rechargeable)

When the battery is qualified against UL1642 standard, the project can be classified as minor. Otherwise project should be classified as major.

The evaluation of the original safety assessment issued to justify the installation of the pre-mod configuration is a prerequisite to proceed with a minor classification. When the original safety assessment is not available, the non-rechargeable lithium battery (NRLB) relocation project should be classified as major.

Note 2 - included in the non-rechargeable Lithium batteries (NRLBs) Special Condition’s of 7th of April 2021- has the intent to allow applicants to substantially increase the level of fire safety of already approved NRLB installations without the need to demonstrate compliance with the special conditions.

Based on "Note 2", the special conditions are not applicable to changes to previously certified non-rechargeable lithium battery installations where the only change is either cosmetic or to relocate the installation to improve the safety of the airplane and occupants. A cosmetic change is a change in appearance only, and does not change any function or safety characteristic of the battery installation. The special conditions are also not applicable to unchanged, previously certified non-rechargeable lithium battery installations that are affected by a change in a manner that improves the safety of its installation. The above exceptions are limited to changes/relocations to baseline aircraft installations approved for certification projects for which the special condition was not applicable.

EASA has determined that allowing the above exceptions is in the public interest because the need to meet all of the special conditions might otherwise deter design changes that may substantially improve safety.

Here an extract of the Special Condition document:
 

Note 2: These special conditions apply in lieu of 25.1353(c)(1) through (c)(4) to non-rechargeable lithium battery installations as follows:

• To all changed installation (new battery part number or new environment) except if the design change can be considered cosmetic. A cosmetic change is a change in appearance only and does not change any function or safety characteristic of the battery installation.

• To all relocated lithium batteries, except if the relocation is demonstrated to improve the safety of the aeroplane and of the occupants, leading to a change that provides a substantial fire safety improvement.

• To all existing non-rechargeable lithium battery installations affected by a design change, even if the battery or battery installation itself does not change.(e.g. change in ambient temperature or pressure environment in which the battery operates, change on the electrical load on a battery). Except if the design change improves the safety of the non-rechargeable lithium battery installation.

Applicants, who intend to justify that this Special Condition is not applicable, shall generate the evidence that the proposed design meets the above criteria in this note 2. This evidence shall include a detailed assessment of the battery installation on the baseline aircraft and the improvement due to the proposed change considering a battery thermal runaway failure for both installations.

The assessment should:

• Consider the battery thermal runaway effects of heat, explosive energy, projecting debris and toxic gases.

• Address the proximity of the battery to occupants, critical systems and equipment, structure, and any other installations that could be a hazard if exposed to a battery thermal runaway (e.g., oxygen bottles/lines, fuel lines).

The above exceptions are limited to changes/relocations to baseline aircraft installations approved for certification projects for which the special condition was not applicable.

CS 25.1353(c)(1) through (c)(4) remains in effect for other battery installations.

General EASA guidance on Level of Involvement (LOI) applies (ref. CM-21.A/21.B-001 Issue 2). Complexity of the project, Applicant Capabilities and past experience with NRLB installation projects should be taken into account to define the EASA LOI in the project.

Yes, according to Part 21 „When the strict application of the paragraph 3.3 criteria from GM 21A.91 Classification of changes to a type Design results in a major classification, the applicant may request re-classification, if justified, and Agency could take the responsibility in re-classifying the change.”

No, the ETSO authorization does not constitute a means of compliance with all the special conditions. In all cases installation aspects shall be taken into account and an assessment of the level of safety of the non-rechargeable lithium battery (NRLB) installation on the aircraft shall be generated, e.g. zonal safety analysis, etc..

Other installations of non-rechargeable lithium batteries (NRLBs) would be classified as MAJOR. Here are some examples of design changes that should be classified as major changes:

Example A
Installation not subject to SC-F25.1353-01 (Special Condition final version published in EASA website on 7th April 2021), when a substantial fire safety improvement is demonstrated based on Note 2 of the special conditions. 

Rationale for MAJOR classification
The evidence that a substantial fire safety improvement is achieved through the relocation of a NRLB shall be discussed and agreed with EASA.

Example B
The design change introduces an exposed installation of a NRLB, even if the battery meets ETSO-C142b  (e.g. ELT installed on a bulkhead in the passenger cabin).

Rationale for MAJOR classification
Despite meeting the minimum performance standards of ETSO C142b provides a higher level of safety, excluding fire and explosions and requesting equipment skin temperatures under 204° C, ejection of gases from the venting provisions included in the battery design is allowed. Quantity, composition and temperature of vented gases are reportable items during ETSO approval and shall be evaluated during installation. DO-227A explains that the hazardous emissions may be flammable, explosive, corrosive or toxic in sufficient concentrations. DO-227A recommends the installer to work with the battery manufacturer to quantify and mitigate the effects of hazardous emissions based on venting capabilities of the battery system and air movement and exchange characteristics at the installed location.

Example C
The design change consists in the installation of a NRLB in the cockpit, even if the battery meets ETSO C-142b.

Rationale for MAJOR classification
The same considerations applicable to example B are valid also for example C. Furthermore, the direct exposure of flight crew members to the effects of a lithium battery thermal runaway event is considered particularly critical.

Example D
The design change consists in the installation of a NRLB in inaccessible areas*, even if the battery meets ETSO-C142b.

*An inaccessible area is an area that can be accessed only after the removal of panels , or is not readily reachable by a person with the contents of a hand-held fire extinguisher. These areas tend to be behind interior panels (such as sidewalls or ceilings), or areas below the passenger floor.

Rationale for MAJOR classification
The same considerations applicable to example B are valid also for example D. Furthermore, the installation of a NRLB in an inaccessible area does not allow crew members to perform effective fire-fighting.

Direct minor classifications (4 Cases):

1. Battery with Capacity up to 100Wh AND installed in the cabin in a fully enclosed area where the occupants can visually localize it in case of fumes or fire AND no oxygen lines/equipment, water, fuel or any other flammable substances in the same enclosure AND battery qualified at least to ETSO-C142b.
    
2. Modifications involving the installation of a Lithium battery within an equipment with a capacity up to 5Wh AND ETSO 142b AND no other reasons to classify the change as Major.
    
3. Relocation of equipment containing a battery with ETSO C142b authorisation and with no impact in the original Safety Assessment AND conditions of installation not worse than the original ones (in terms of separation to oxygen lines/equipment, water, fuel, other flammable substances, heat points).
    
4. Project requesting exemptions to Special Condition as per Note 2 on Special Conditions’ final version published in EASA website on 7th April 2021 are limited to cosmetic changes.

NOTE: Changes expected to demonstrate substantial fire safety improvement as per Note 2 are considered as MAJOR.

No, it is superseded. Some types of design changes previously eligible for reclassification as minor will have to be classified as major. The new approach applies to projects starting on or after 1st January 2022.

The same policy is currently applicable to CS-25 aircraft types applies also to CS-29 aircraft types. The approach to be used for CS-23 and CS-27 aircraft types still under discussion.

The TCDS of the vast majority of CS-25 aircraft includes special conditions on non- rechargeable lithium batteries (NRLBs) installation. Just a few models remain for which special conditions have not been released. If your project applies to one of those models, please contact EASA. 

Yes, see the following “Non rechargeable Lithium batteries installation minor/Major classification flowchart”

EASA intends that every single non/rechargeable Lithium battery installation shall be compliant with ETSO C142b or that any installation has to assure qualification level according to MOPS DO-227A or later standards. 

The entry into force date will be based on the safety gain resulting from the installation of non-rechargeable lithium batteries meeting this MOPS DO-227A standard (and ff.) and the expected availability of ETSO C142b/DO-227A equipment. 

The upcoming deadline for applications will be set to ensure that an adequate number of equipment compliant with ETSO C142b/DO-227A is available in the market thus leading to a smooth transition to the new approach. 

It will lead to Means of Compliance (MoC) based on installation of ETSO C142a/MOPS DO-227 equipment complemented with a risk assessment at A/C level, as MoC with the Special Conditions applicable to Non-rechargeable Lithium Battery Installations (ref. SC-F25.1353-01) will not be accepted after the entry into force date of the new approach.