21.B.450  Type-certification basis and environmental protection requirements for a repair design approval

Regulation (EU) 2019/897

The Agency shall designate any amendments to the type-certification basis incorporated by reference in, as applicable, either the type-certificate, the supplemental type-certificate or the APU ETSO authorisation, which the Agency considers necessary for maintaining a level of safety equal to that previously established and notify them to the applicant for a repair design.

21.B.453 Issuance of a repair design approval

Regulation (EU) 2022/201

(a) The Agency shall issue an approval of a major repair design, provided that:

1. the applicant has demonstrated its capability in accordance with point 21.A.432B;

2. the applicant has complied with point 21.A.433;

3. the Agency, through its verification of the demonstration of compliance in accordance with the level of involvement established pursuant to point 21.B.100(a), has not found any non-compliance with the type-certification basis and environmental protection requirements; and

4. no feature or characteristic has been identified that may make the product unsafe for the uses for which certification is requested.

(b) The Agency shall issue an approval of a minor repair design, provided that the applicant has complied with points (2) and (4) of point (a) and provided that the Agency, through its verifications of the demonstration of compliance in accordance with the level of involvement pursuant to point 21.B.100(b), has not found any non-compliance with the type-certification basis and environmental protection requirements.